01-07-2016, 15:26
Yes i do.
I tried to connect the serial.
pin 2 - TX
Pin 3 - RX
Pin 5 Ground
I connected it to the controller on the new pins i soldered on.
I allso left the ST-link on the ground and 5V pin, just to supply the board with power.
But i think that the Tx/RX pins is set to the wrong locations, as it cannot see the controller.
I tried to connect the serial.
pin 2 - TX
Pin 3 - RX
Pin 5 Ground
I connected it to the controller on the new pins i soldered on.
I allso left the ST-link on the ground and 5V pin, just to supply the board with power.
But i think that the Tx/RX pins is set to the wrong locations, as it cannot see the controller.